Product Details:
Payment & Shipping Terms:
|
Product Name: | RO Membrane | Function: | Remove Virus,bacteria |
---|---|---|---|
Certification: | ISO9001 | Application: | Chemical |
Salt Rejection: | 96% | Max.water Flow: | 2(0.46) |
High Light: | ro membrane filter,ro filter membrane replacement |
Chemical Household Water Purifier Membrane Ro System Membrane Replacement
Special Features:
1. Description
8040/4040 RO membrane element is used for the desalination of brackish water and other similar water and it has high desalination rate and long time stable performance under high flow and low operating pressure.
2. Applications:
It is used to produce pure water or ultra pure water in electronics, power, petrochemical, food, beverage and pharmacy.
Notice: Permeate flow for individual elements may vary ±15 percent.
The stated performance is initial (data taken after 30 minutes of operation), based on the following conditions:
1. 450PPM NaCl solution,tap water
2. Applied Pressure: psi(Mpa) refer to the form
3. 77°F (25°C) Operating Temperature
4. 30% Permeate Recovery
5. 7.0~8.0 pH Range
Standard Operating Limits:
Maximum Operating Temperature: 113ºF (45ºC)
Maximum Applied Pressure: 300psi(21bar)
pH Range, Continuous (Cleaning): 3-10
Maximum Feedwater SDI (15 mins): 4
Maximum Chlorine Concentration: < 0.1 PPM
limiting condition for operation (LCO)
Under certain conditions, the presence of free chlorine and other oxidizing agents will cause premature membrane failure. Since oxidation damage is not covered under warranty, GALLON recommends removing residual free chlorine by pretreatment prior to membrane exposure. Please refer to GALLON technical bulletin for more information.
When pH Range> 10,maximum Operating Temperature less 95℉(35℃)
Compared with other systems in this field, it has a lot of advantages as follows:
1. With ingenious and compact design, it takes up a small area and has a high automatic performance.
2. Clean and clear filtration water without the problems of olid smell and getting turbid.
3. Adopting automatic control system, including automatic back-washing, needing no one on duty, saving labor cost, solving the problem effectively of the traditional equipments' complicated operation and invalidation due to the operating or protecting improperly.
4. Stable performance, long life time, low running cost.
5. Environment friendly, no second pollution.
6. More than 90% water reuse rate, no natural wastage..
Contact Person: Benson
Tel: 86-13530341575
Fax: 86-0755-27415005